Acura ILX Hybrid (2015 year). Instruction — page 9

uuInterior Lights/Interior Convenience Items uInterior Convenience Items
Interior Convenience Items
1Glove Box
Glove Box
Pull the handle to open the glove box. You
3WARNING
can lock the glove box with the built-in key.
An open glove box can cause serious injury
to your passenger in a crash, even if the
passenger is wearing the seat belt.
To Lock
Always keep the glove box closed while
driving.
Glove Box
Console Compartment
Press the button to open the console
compartment.
Button
142

uuInterior Lights/Interior Convenience ItemsuInterior Convenience Items
1Beverage Holders
Beverage Holders
NOTICE
Front seat beverage holders
Spilled liquids damage the upholstery, carpeting, and
Are located in the console between the front
electrical components in the interior.
seats.
Be careful when you are using the beverage holders.
Hot liquid can scald you.
Rear seat beverage holders
Fold the armrest down to use the rear seat
beverage holders.
Continued
143

uuInterior Lights/Interior Convenience Items uInterior Convenience Items
1Accessory Power Socket
Accessory Power Socket
NOTICE
The accessory power sockets can be used when the power mode is in ACCESSORY
Do not insert an automotive type cigarette lighter
or ON.
element.
Open the console lid and the cover to use it.
This can overheat the power socket.
NOTICE
Do not operate the tire repair kit compressor for
more than 15 minutes. The accessory power socket
and compressor can overheat and become
permanently damaged.
The accessory power socket is designed to supply
power for 12 volt DC accessories that are rated 180
watts or less (15 amps).
Coat Hook
To prevent battery drain, only use the power socket
There is a coat hook on the rear left grab
with the engine running.
handle. Pull it down to use it.
1Coat Hook
The coat hook is not designed for large or heavy
items.
144

uuInterior Lights/Interior Convenience ItemsuInterior Convenience Items
1Seat Heaters*
Seat Heaters*
The power mode must be in ON to use the
3WARNING
seat heaters. The HI setting heats the seats
Heat induced burns are possible when
faster than the LO setting.
using seat heaters.
There is no heater in the passenger’s seat-
Persons with a diminished ability to sense
back due to the side airbag cutoff system.
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
While in HI, the heater cycles on and off.
u The appropriate indicator will be on
Do not use the seat heaters even in LO when the
while the seat heater is on. Briefly press
engine is off. Under such conditions, the battery may
the switch on the opposite side to turn
be weakened, making the engine difficult to start.
the heater off. The indicator will be off.
When a comfortable temperature is
In the LO setting, the heater runs continuously and
does not automatically turn off.
reached, select LO to keep the seat
warm.
* Not available on all models
145

Climate Control System
Using Automatic Climate Control
The automatic climate control system maintains the interior temperature you select.
1Using Automatic Climate Control
The system also selects the proper mix of heated or cooled air that raises or lowers
If any buttons are pressed while using the climate
the interior temperature to your preference as quickly as possible.
control system in auto, the function of the button
that was pressed will take priority.
/
Passenger’s Side
(Fan Control) Buttons
Temperature
The AUTO indicator will go off, but functions
Control Dial
unrelated to the button that were pressed will be
(ON/OFF) Button
controlled automatically.
SYNC
(Synchronized) Button
Driver’s Side Temperature
During the Auto Idle Stop, the air conditioning
Control Dial
system will be turned off.
(Recirculation) Button
AUTO Button
If the ECON mode is selected, the fan may also be
A/C (Air Conditioning) Button
turned off.
To prevent cold air from blowing in from outside, the
Floor and
Dashboard
fan may not start immediately when the AUTO
Dashboard
defroster
Floor vents
and floor
vents
button is pressed.
vents
vents
Use the system when the engine is running.
If the interior is very warm, you can cool it down
more rapidly by partially opening the windows,
1. Press the AUTO button.
turning the system on AUTO, and setting the
2. Adjust the interior temperature using the driver’s side or passenger’s side control
temperature to low. Change the fresh mode to
dial.
recirculation mode until the temperature cools down.
3. Press the
(ON/OFF) button to cancel.
When you set the temperature to the lower or upper
Switching between the recirculation and fresh air modes
limit, Lo or Hi is displayed.
Press the
(recirculation) button and switch the mode depending on
environmental conditions.
Recirculation Mode (indicator on): Recirculates air from the vehicle’s interior through
the system.
Fresh Air Mode (indicator off): Maintains outside ventilation. Keep the system in
fresh air mode in normal situations.
146

uuClimate Control SystemuUsing Automatic Climate Control
1Using Automatic Climate Control
Defrosting the Windshield and Windows
Pressing the
button switches the climate
Pressing the
(windshield defroster) button
control system between on and off. When turned on,
turns the air conditioner system on and
the system returns to your last selection.
automatically switches the system to fresh air
mode.
While in the ECON mode, the climate control system
has greater temperature fluctuations.
Press the
button again to turn off, the
1Defrosting the Windshield and Windows
system returns to the previous settings.
For your safety, make sure you have a clear view
through all the windows before driving.
Do not set the temperature near the upper or lower
To rapidly defrost the windows
limit.
1. Press the
button.
When cold air hits the windshield, the outside of the
2. Press the
button.
windshield may fog up.
If the side windows fog up, adjust the vents so that
the air hits the side windows.
1To rapidly defrost the windows
After defrosting the windows, switch over to fresh air
mode. If you keep the system in recirculation mode,
the windows may fog up from humidity. This
impedes visibility.
147

uuClimate Control SystemuSynchronized Mode
Synchronized Mode
1Synchronized Mode
When you press the
button, the system changes
to synchronized mode.
When the system is in dual mode, the driver side
temperature and the passenger side temperature can
be set separately.
You can set the temperature synchronously for the driver side and the passenger
side in synchronized mode.
1. Press the SYNC button.
u The system will switch to synchronized mode.
2. Adjust the temperature using driver’s side temperature control dial.
Press the SYNC button to return to dual mode.
148

uuClimate Control SystemuAutomatic Climate Control Sensors
Automatic Climate Control Sensors
The automatic climate control system is
Sensor
equipped with sensors. Do not cover or spill
any liquid on them.
Sensor
149

Audio System
About Your Audio System
Models with navigation system
1About Your Audio System
See the Navigation System Manual for operation of the audio system, AcuraLink*,
XM® Radio is available on a subscription basis only.
Bluetooth® HandsFreeLink®, and voice commands for these features.
For more information on XM® Radio, contact a
dealer.
2 General Information on the Audio System
The audio system features AM/FM radio and the XM® Radio service. It can also play
P. 183
audio CDs, WMA/MP3/AAC files, USB flash drives, and iPod, iPhone and Bluetooth®
devices.
XM® Radio is available in the United States and
Canada, except Hawaii, Alaska, and Puerto Rico.
You can operate the audio system from the buttons and switches on the panel, or
the remote controls on the steering wheel.
XM® is a registered trademark of Sirius XM Radio, Inc.
Video CDs, DVDs, and 3-inch (8-cm) mini CDs are not
supported.
iPod
iPod, iPhone and iTunes are trademarks of Apple Inc.
State or local laws may limit the circumstances in
which you can launch or control your attached audio
USB Flash
Drive
device.
Remote Control
152
* Not available on all models

uuAudio SystemuUSB Adapter Cable
USB Adapter Cable
1. Unclip the USB connector and loosen the
1USB Adapter Cable
adapter cable.
Do not leave the iPod or USB flash drive in the
2. Install the iPod dock connector or the USB
vehicle. Direct sunlight and high temperatures may
flash drive to the USB connector.
damage it.
Do not use an extension cable with the USB
adapter cable.
Do not connect the iPod or USB flash drive using a
hub.
Do not use a device such as a card reader or hard
disk drive, as the device or your files may be
damaged.
We recommend your data backed up before using
Auxiliary Input Jack
the device in your vehicle.
Displayed messages may vary depending on the
Use the jack to connect standard audio devices.
device model and software version.
1. Open the AUX cover.
2. Connect a standard audio device to the
If the audio system does not recognize the iPod, try
input jack using a 1/8 inch (3.5 mm) stereo
reconnecting it a few times or reboot the device. To
miniplug.
reboot, follow the manufacturer’s instructions
u The audio system automatically switches
provided with the iPod or visit www.apple.com/ipod.
to the AUX mode.
1Auxiliary Input Jack
To switch the mode, press any of the audio mode
buttons. You can return to the AUX mode by
pressing the AUX button.
153

uuAudio SystemuAudio System Theft Protection
Audio System Theft Protection
The audio system is disabled when it is disconnected from the power source, such as
1Audio System Theft Protection
when the battery is disconnected or goes dead.
Find the audio system’s security code and serial
number label in your owner’s manual kit.
Reactivating the audio system
We recommend that you write down the serial
1. Set the power mode to ON, and turn on the audio system.
number in this owner’s manual.
u You will be requested to enter the audio security code. See step 3.
2. Press and hold the power button again for more than two seconds.
Do not store the label in your vehicle. If you lose the
u The audio system is reactivated when the system’s control unit recognizes that
label, you must first retrieve the serial number, and
the system is in your vehicle.
then obtain the code.
If the control unit fails to recognize, ENTER CODE appears on the audio/
information screen.
You can find out about your serial number and
security code from a dealer.
3. Enter the audio security code using the preset buttons. If you enter an incorrect
digit, continue to the last digit, then try again. If you do not enter the code
U.S. models
correctly after 10 tries, leave the system for one hour before trying again, or visit
You can register the security code at Acura Owners
a dealer to have the system reset.
(owners.acura.com.), and find information on how to
retrieve the serial number and obtain the code at
radio-navicode.acura.com.
154

Audio System Basic Operation
To use the audio system function, the power mode must be in ACCESSORY or ON.
1Audio System Basic Operation
BACK Button
SETUP Button
Use the selector knob or SETUP button to
These indications are used to show how to operate
access some audio functions.
the selector knob.
Rotate
to select.
Press
to switch between the normal and
Press
to enter.
extended display for some functions.
Press the MODE, +, ,
or
button on the
steering wheel to change any audio setting.
2 Audio Remote Controls P. 159
Button
Selector Knob
Setup Menu Items
Selector knob: Rotate left or right to scroll
Menu Display
2
RDS Information P. 162
through the available choices. Press
to set
2
Sound Settings P. 160
your selection.
2
Play Mode P. 167, 170, 175
SETUP button: Press to select any mode such
2
Resume/Pause P. 177
2
Adjust Clock P. 104
as the RDS Information, Sound Settings,
Play Mode, Resume/Pause, or Adjust
Clock.
BACK button: Press to go back to the
previous display.
button: Press to change the audio/
information screen brightness. The brightness
can be set differently for the day time and
night time.
Pressing the button switches the modes
between daytime and night time.
Adjust the brightness using
155

uuAudio System Basic OperationuAudio/Information Screen
Audio/Information Screen
Displays audio status and wallpaper, and allows you to go to various setup options.
Switching the Display
Press DISPLAY button. Rotate
and select the mode from the three display
modes.
Press
DISPLAY
Button
Selector Knob
156

uuAudio System Basic OperationuAudio/Information Screen
Audio Display
Shows the current audio information.
2 Audio System Basic Operation P. 155
Wallpaper
Shows a clock screen or an image you import.
2 Wallpaper Setup P. 178
Minimum Display
Minimizes the display by only showing the clock and audio status on the display.
Setting Options
1. Press the SETUP button.
2. Rotate
and select the setup option you
want to change. Press
Continued
157

uuAudio System Basic OperationuAudio/Information Screen
Language Selection
1. Rotate
to select Language Selection,
then press
2. Rotate
to select the language, then
press
158

uuAudio System Basic OperationuAudio Remote Controls
Audio Remote Controls
Allow you to operate the audio system while driving.
1Audio Remote Controls
MODE Button
The CD mode appears only when a CD is loaded.
VOL Button
MODE Button
Cycles through the audio modes as follows:
FM1
FM2
AM XM1* XM2* CD AUX
When in AUX mode, the following are operable from
the remote controls:
iPod/USB flash drive connected to the USB adapter
cable
Bluetooth® Audio (with some phones only)
CH Button
VOL (Volume) Button
Press
: To increase the volume.
Press
: To decrease the volume.
CH (Channel) Button
• When listening to the radio
Press +: To select the next preset radio station.
Press : To select the previous preset radio station.
Press and hold + : To select the next strong station.
Press and hold : To select the previous strong station.
• When listening to a CD, iPod, USB flash drive, or Bluetooth® Audio
Press +: To skip to the next song.
Press : To go back to the beginning of the current or previous song.
• When listening to a CD, USB flash drive
Press and hold + : To skip to the next folder.
Press and hold : To go back to the previous folder.
• When listening to Pandora®*
Press +: To skip to the next song.
* Not available on all models
159

uuAudio System Basic OperationuAdjusting the Sound
Adjusting the Sound
Press the SETUP button, and rotate
to
1Adjusting the Sound
SETUP Button
select Sound Settings, then press . Rotate
The SVC has four modes: Off, Low, Mid, and High.
SVC adjusts the volume level based on the vehicle
to scroll through the following choices:
speed. As you go faster, audio volume increases. As
you slow down, audio volume decreases.
Selector Knob
Bass
Treble
Fader
Balance
Subwoofer*
Speed-sensitive Volume
Compensation
Treble is selectable.
160
* Not available on all models
Оцените статью
Инструкции по ремонту
Добавить комментарий