Acura RL. Instruction — page 355

Fig. 703: Identifying Bearing Outer Race, Transfer Cover And Trust Shim
Courtesy of AMERICAN HONDA MOTOR CO., INC.

45. Drive the outer race securely in the cover using the driver and the attachment (78 x 80 mm) so there is no

clearance between the outer race, thrust shim, and cover.

Fig. 704: Pressing Outer Race
Courtesy of AMERICAN HONDA MOTOR CO., INC.

46. After replacing the 80 mm thrust shim, recheck and make sure that the total starting torque is within the

specification.

47. Install the new O-ring (A) on the transfer cover (B), then install the cover on the transfer housing (C).

2007 Acura RL

2005-08 TRANSMISSION Automatic Transmission — RL

me

Friday, June 05, 2009 1:18:20 PM

Page 591

© 2005 Mitchell Repair Information Company, LLC.

Fig. 705: Identifying O-Ring And Transfer Cover With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.

48. Remove the filler plug (A), then refill the transfer assembly with transfer fluid (hypoid gear oil). Use an

SAE 90 or SAE 80W-90 viscosity hypoid gear oil, API classified GL4 or GL5 only.

Viscosity:

SAE 90: Above 0°F (-181°C)

SAE 80W-90: Below 0° (-18°C)

Hypoid Gear Oil Capacity: 0.45 L (0.48 US qt)

Fig. 706: Identifying Filler Plug And Sealing Washer With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.

49. Install the filler plug with a new sealing washer (B).

2007 Acura RL

2005-08 TRANSMISSION Automatic Transmission — RL

me

Friday, June 05, 2009 1:18:20 PM

Page 592

© 2005 Mitchell Repair Information Company, LLC.

GENERAL INFORMATION

Trouble Shooting — Basic Procedures

* PLEASE READ THIS FIRST *

ACCESSORIES & ELECTRICAL

CHARGING SYSTEM TROUBLE SHOOTING

BASIC CHARGING SYSTEM TROUBLE SHOOTING CHART

NOTE:

This is GENERAL information. This article is not intended to be specific to
any unique situation or individual vehicle configuration. The purpose of this
Trouble Shooting information is to provide a list of common causes to
problem symptoms. For model-specific Trouble Shooting, refer to SUBJECT,
DIAGNOSTIC, or TESTING articles available in the section(s) you are
accessing.

NOTE:

This is GENERAL information. This article is not intended to be specific to
any unique situation or individual vehicle configuration. The purpose of this
Trouble Shooting information is to provide a list of common causes to
problem symptoms. For model-specific Trouble Shooting, refer to SUBJECT,
DIAGNOSTIC, or TESTING articles available in the section(s) you are
accessing.

NOTE:

This is GENERAL information. This article is not intended to be specific to
any unique situation or individual vehicle configuration. The purpose of this
Trouble Shooting information is to provide a list of common causes to
problem symptoms. For model-specific Trouble Shooting, refer to SUBJECT,
DIAGNOSTIC, or TESTING articles available in the section(s) you are
accessing.

CONDITION & POSSIBLE CAUSE

CORRECTION

Vehicle Will Not Start

Dead battery

Check battery cells, alternator

belt tension and alternator

output

Loose or corroded battery connections

Check all charging system

connections

Ignition circuit or switch malfunction

Check and replace as necessary

Alternator Light Stays On With Engine Running

Loose or worn alternator drive belt

Check alternator drive tension

and condition, See Belt

Adjustment in TUNE-UP

article in the TUNE-UP section

Loose alternator wiring connections

Check all charging system

connections

2007 Acura RL

GENERAL INFORMATION Trouble Shooting — Basic Procedures

2007 Acura RL

GENERAL INFORMATION Trouble Shooting — Basic Procedures

me

Friday, June 05, 2009 2:26:48 PM

Page 1

© 2005 Mitchell Repair Information Company, LLC.

me

Friday, June 05, 2009 2:26:59 PM

Page 1

© 2005 Mitchell Repair Information Company, LLC.

Short in alternator light wiring

See Indicator Warning Lights in

STANDARD INSTRUMENTS

in the ACCESSORIES &

EQUIPMENT section

Defective alternator stator or diodes

See Bench Tests in

ALTERNATOR article

Defective regulator

See Regulator Check in

ALTERNATOR article

Alternator Light Stays Off With Ignition Switch ON

Blown fuse

See WIRING DIAGRAMS

Defective alternator

See Testing in ALTERNATOR

article

Defective indicator light bulb or socket

See Indicator Warning Lights in

STANDARD INSTRUMENTS

in the ACCESSORIES &

EQUIPMENT section

Alternator Light Stays OFF With Ignition Switch ON

Short in alternator wiring

See On-Vehicle Tests in

ALTERNATOR article

Defective rectifier bridge

See Bench Tests in

ALTERNATOR article

Lights or Fuses Burn Out Frequently

Defective alternator wiring

See On-Vehicle Tests in

ALTERNATOR article

Defective regulator

See Regulator Check in

ALTERNATOR article

Defective battery

Check and replace as necessary

Ammeter Gauge Shows Discharge

Loose or worn drive belt

Check alternator drive belt

tension and condition. See Belt

Adjustment in TUNE-UP

article in the TUNE-UP section

Defective wiring

Check all wires and wire

connections

Defective alternator or regulator

See Bench Tests and On-

Vehicle Tests in

ALTERNATOR article

Defective ammeter, or improper ammeter wiring connection

See Testing in STANDARD

INSTRUMENTS in the

ACCESSORIES &

EQUIPMENT section

Noisy Alternator

Loose drive pulley

Tighten drive pulley attaching

nut

Loose mounting bolts

Tighten all alternator mounting

bolts

Worn or dirty bearings

See Bearing Replacement

2007 Acura RL

GENERAL INFORMATION Trouble Shooting — Basic Procedures

me

Friday, June 05, 2009 2:26:48 PM

Page 2

© 2005 Mitchell Repair Information Company, LLC.

Оцените статью
Инструкции по ремонту
Добавить комментарий